Stainless Steel laser welded finned tube

2022-04-18

Finned Tubes are part of many heating equipment, and as heating equipment, it is necessary to choose better finned tubes. The Stainless steel material can make the Finned Tube more resistant to corrosion, and the seismic performance will also be enhanced. In general, the service life of the finned tube is at least three times as long. The choice of stainless steel fins can make the performance of the finned tube better than others. Material. Although the wall thickness of the finned tube will increase, it is also important to increase its thermal conductivity and thermal conductivity. The finned tube production process adopts a better process production effect. In terms of the economic benefits of using finned tubes, stainless steel materials are also better.

Finned Tubes

The distance between the Finned Tube Heat Exchanger and the finned tube mainly considers factors such as dust accumulation, dust removal, and easy cleaning, and strictly meets the equipment pressure reduction requirements. When arranging, the distance between the pipes is not easy to be too large, generally more than 1mm above the pipes can be arranged. During the heat exchange process, when the air passes through the finned tube Heat Exchanger, the fins on the front and back sides are mainly involved in the heat exchange. There is only a small amount of radiation heat transfer in the middle of the two finned tubes, and the heat transfer effect is not obvious.

Finned Tubes

Installation and regular inspection: The Stainless Steel Finned Tube has good heat dissipation performance, high thermal efficiency, and long service life of the product. The finned tube is directly wound on the outer surface of the heating tube and is mainly used for drying heating. When the equipment is operating, the main heat medium is air. After the stainless steel finned tube has been used for a period of time, it is necessary to regularly check the product to check whether there is coking, sediment and rust layer in the equipment. If this happens, regular cleaning is required. At the same time, it is necessary to timely check whether the adhesion of the rubber gasket is tight

Previous: Introduction to laser welding wing tube craftsmanship Next: Regarding the high adaptability of stainless steel finned tubes

Mr. Mike

Email:

mike@cnmcway.com

Send Inquiry

Tel:+86-0510-85189125

Fax:

Mobile Phone:+8618851577799

Email:mike@cnmcway.com

Address:406, Henghua Science park, No.20, No.58, Xiuxi Road, Binhu District, Wuxi, Jiangsu